ELECTRIC STAPLER/NAILER ■ STOCK No.56338 ■ STOCK No.61516 ■ PART No.STNE ■ PART No.STNE(A) • INSTRUCTIONS • IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE SAFE AND EFFECTIVE USE OF THIS TOOL.
SPECIFICATION Whilst every effort has been made to ensure that the information given in this manual is correct at the time of going to print, the Draper Tools policy of continuous improvement determines the right to change specification without notice. STOCK No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .56338/61516. PART No. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
GENERAL SAFETY INSTRUCTIONS FOR POWER TOOLS WARNING Please read the following instructions carefully, failure to do so could lead to serious personal injury. IMPORTANT Draper Tools Limited recommends that this machine should not be modified or used for any application other than that for which it was designed. If you are unsure of its relative applications do not hesitate to contact us in writing and we will advise you. 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14.
POWER SUPPLY CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (240V ONLY) To eliminate the possibility of an electric shock, your machine has been fitted with a BS approved, rewireable moulded plug and cable which incorporates a fuse, the value of which is indicated on the pin face of the plug. Should the fuse need to be replaced an approved BS1362 fuse must be used of the same rating, marked thus . If the fitted plug is not suitable, it should be cut off and destroyed.
TO OPERATE There are three safety related switches, rocker main switch, switch pin and safety yoke (Fig. 1). For safe use, the operating steps should take in the order of: A. Connect the plug to a socket on wall or on extension cord. B. Turn on the main switch. C. Place the tool so that the safety yoke is lightly in contact with the workpiece. D. Push the switch pin to the right. E.
TO OPERATE CONT. Fig. 5 3. Reset the staple-feeder (Fig. 5). Fig. 6 4. Quick clogging release (Fig. 6). A. Refer to step 1 to take staplefeeder all the way out. B. Push the OPEN/LOCK switch upwards to “OPEN” position. C. Push staple-channel slightly backwards before pulling it down. D. Staple-channel will tile for cleaning. E. Take out the jammed fastener by tweezers or pliers. To clean: Use only dry cloth to clean the housing. Use of aggressive or alcoholic cleaners is not permissible.
NOTES -6-
DRAPER TOOLS LIMITED, Hursley Road, Chandler's Ford, Eastleigh, Hants. SO53 1YF. England. Tel: (023) 8026 6355. Fax: (023) 8026 0784. YOUR DRAPER STOCKIST ©Published by Draper Tools Ltd. No part of this publication may be reproduced, stored in a retrieval system or transmitted in any form or by any means, electronic, mechanical photocopying, recording or otherwise without prior permission in writing from Draper Tools Ltd.