Owner`s manual

- 12 -
CONTOUR SANDING (Fig.15):
Inside contours: Inside curves can be
sanded on the drums at either end of
the machine. Hold the work firmly, press
the contour lightly against the drum on
one side and move the work slowly
across the drum while moving up the
contour against the drum.
Outside contours: Outside curves can
be sanded on the belt table of the
unsupported side of the belt with the
table in the vertical position.
Hold the work firmly. Begin the curve
lightly against one side and feed it
across the belt towards the other side
while moving up the contour of the
workpiece.
Outside contours on the end of a
workpiece can be sanded with the
sanding disc. Feed the work lightly
against the disc and move it back and
forth from the centre of the disc to the
outside edge.
DISC SANDING (Fig.16):
Disc sanding should be done on the
outer edge of the disc which revolves
downward. Applying the workpiece to
the “UPSIDE” of the disc may cause it to
fly up, which could be dangerous to the
operator.
The mitre gauge ✳✌ is very useful as a
guide when chamfering and finishing
angle sanding.