Programming instructions

RTS Receiver for Standard Motor
®
The Universal Receiver provides RTS capability to standard
motors. It can be used stand-alone as a radio control, or with RTS
sensors for sun and wind control. Tow user-defi ned intermediate posi-
tions can be programmed. This control is packaged in a weatherproof
enclosure and includes watertight strain-relief fi ttings for wires enter-
ing the box.
Part No.: C156.120
INSTALLATION PROCEDURES
1 The Universal Receiver should be mounted as close to the motor as
possible. If mounted outside, ensure that the connections are facing down
to avoid rain seepage. Avoid mounting the control against any metallic
surface, as this may affect radio reception.
2 Connect high voltage wires according to the wiring diagram on the next
page. Make sure to use included watertight strain relief fi ttings to maintain
the weatherproofi ng of the enclosure.
3 If used, the RTS sensor should be placed close to the awning or shading
system to make sure the wind speed or sun intensity is measured at the
product. Guard against installing the wind sensor too close to an obstruc-
tion such as a chimney, gutter or the window covering itself, which could
block the wind and cause erroneous sensor readings. The sensor should
also not be mounted in the shade or be obstructed by trees, to ensure
accurate sunlight readings.
PROGRAMMING PROCEDURES
RECORDING THE INTERMEDIATE POSITION FROM THE TOP OF THE WINDOW TREATMENT
- Bring the window treatment to its upper limit using the Telis transmitter. Press the DOWN and MY buttons simultaneously until the awning begins to move,
then release.
- Stop the window treatment at the intermediate position desired. Press the MY button for 2 seconds to memorize that position.
RECORDING THE INTERMEDIATE POSITION FROM THE BOTTOM OF THE WINDOW TREATMENT
- Bring the motorized treatment to its lower limit. Press the UP and MY buttons simultaneously until the awning begins to move, then release.
- Stop the window treatment at the position desired. Press the MY button for 2 seconds to memorize that position.
DELETING AN INTERMEDIATE POSITION
- Briefl y press the MY button of the Telis transmitter to reach the desired intermediate position.
- Continue to press the MY button for 10 seconds until the programming lED on the Central is Receiver stops blinking. That position is now deleted.
TO ADD A NEW TRANSMITTER or SENSOR TO THE MEMORY OF THE RECEIVER
- Press the programming button, for more than 2 seconds, on a transmitter that is already memorized by the Universal Receiver to wake up the receiver. The
programming lED on the Receiver will blink, and the motor will jog. Press the programming button on the new transmitter or sensor to attach it to the
Universal Receiver. The programming lED on the receiver will light and the motor will jog indicating the transmitter or sensor is memorized.
TO REMOVE A TRANSMlffi R or SENSOR FROM THE MEMORY OF THE RECEIVER
- Press the programming button, for more than 2 seconds, on a transmitter that is already memorized by the Universal Receiver to wake up the receiver. The
programming lED on the Receiver will blink, and the motor will jog. Press the programming button on the transmitter or sensor you want to remove from
memory. The programming lED on the receiver will light and the motor will jog indicating that transmitter or sensor will no longer operate the Universal
Receiver.
TO REMOVE All TRANSMITTERS or SENSORS FROM THE MEMORY OF THE RECEIVER
- Press and hold the programming button of the Unviersal Receiver for more than 7 seconds until the lED blinks and the motor jogs twice. This removes All
memorized transmitters or sensors.
Page 26 of 124