Programming instructions

OPERATING INSTRUCTIONS
System Set Up
① With power off, wire the Universal Receiver as indicated above. Turn all circuit breakers on (motors should not move).
② The motor can be tested using the sequence button located on the Universal Receiver board. Each press of the switch will sequence through
the directions as follows;
DEPRESS 1 UP DIRECTION
DEPRESS 2 STOP
DEPRESS 3 DOWN DIRECTION
DEPRESS 4 STOP
③ Set the Universal Receiver into programming mode by pressing the programming button on the receiver until the LED lights (about 2
seconds). The motor will jog.
④ Press the programming button on the Teli transmitter or RTS sensor to be memorized. The programming LED will blink and the motor will jog
indicating the transmitter has been memorized.
⑤ Operate the motor in the DOWN direction using the radio transmitter.
⑥ The motorized window covering should move down or out. If this is incorrect, turn off the circuit breakers and reverse the red and black wires
of the motor.
Operating Procedures
REMOTE ONLY CONTROL
① Pressing the UP button on the Telis transmitter will move the window treatment up or in. The DOWN button will move the treatment down
or out.
② To stop the motorized product at any time, press the MY button on the transmitter.
③ To reach one of the intermediate positions, the window treatment must fi rst be at the upper or lower limit, and stopped. Pressing the MY
button on the transmitter will move the window treatment to the desired position.
WIND ONLY OPERATION
④ If wind monitoring is desired, an Eolis Sensor RTS or Eolis Wirefree must fi rst be memorized into the receiver. Press the programming button
on the receiver until the LED blinks and the motor jogs. Press the programming button on the bottom of the sensor. The programming LED on
the receiver will light and the motor will jog, indicating the sensor has been memorized.
⑤ Set the desired wind speed on the sensor as specifi ed in the product's operating instructions.
⑥ When the monitored wind speed is greater than the setting, the UP direction will activate after 2 seconds. As long as the wind speed remains
high, all other commands will be ignored.
⑦ When the wind speed drops below the set value, a manual command can be given with the radio transmitter after only one minute.
SUN AND WIND OPERATION
⑧ If sun and wind monitoring is desired, an Eolis Sensor RTS or combination Eolis Wirefree and Sunis must fi rst be memorized into the receiver.
Press the programming button on the receiver until the LED blinks and the motor jogs. Press the programming button on the sensor. The
programming LED on the receiver will light and the motor will jog, indicating hte sensor has been memorized.
⑨ Set the desired wind speed and sun intensity on the sensor as specifi ed in the product's operating instructions.
⑩ When the monitored wind speed is greater than the setting, the UP direction will activate after 2 seconds. As long as the wind speed remains
high, all other commands will be ignored.
⑪ When the measured sun intensity is greater than the set level, a DOWN command is given after a 2 minute delay, assuming no wind is
present. If the upper intermediate position is set, the shade will go to that position. Otherwise, it will go to the lower limit.
⑫ When the sun intensity falls below the set level, the shade will automatically retract after a 15-30 minute delay, assuming no wind is present.
RTS Receiver for Standard Motor
Page 2 of 2
Page 27 of 124