Programming instructions

Radio Motor Transmitters
There are several types of radio motor transmitters, and here is a listing of them and when you need them. A radio motor can learn up to
twelve different transmitters.
- Single Channel Transmitter, C072.011 —This is a one channel remote for operating one shade or one group of shades. It is able to
send an up, stop, down, and intermediate stop command.
- Four Channel Transmitter, C072.012—This is a four channel remote with a 5th channel that can be used as well for operating up to 5
groups of shades in individually or 4 groups individually and as a group. It is able to send an up, stop, down, and intermediate stop com-
mand per channel.
- Single Channel Wall Switch, C112.074—This is a one channel wall switch for operating one shade or one group of shades. It is able to
send an up, stop, down, and intermediate stop command.
- Four Channel Wall Switch, C112.076—This is a four channel remote with a 5th channel that can be used as well for operating up to 5
groups of shades in individually or 4 groups individually and as a group. It is able to send an up, stop, down, and intermediate stop com-
mand per channel.
- 20 Channel Transmitter, C072.043—This is a 20 channel remote which can be used to operate 20 groups of shades. It has timer,
vacations, and other user functions that one may enjoy. A single or four channel remote is required to fi rst set the motor limits before
using this transmitter.
- Chronis Timer, C072.033—This single channel transmitter is used to run radio motors at certain programmed times. A single or four
channel remote is required to fi rst set the motor limits before using this transmitter.
- Dry Contact Interface, C156.100—This single channel transmitter sends out a command based on the connections made on the dry
contact inputs. This device is used for interfacing radio motors with low voltage control systems. A single or four channel remote is
required to fi rst set the motor limits before using this transmitter.
- Universal RTS Interface, C156.101—This is a 16 channel transmitter which sends out commands based on the inputs of IR, RS 232,
and RS 485 that it receives. A single or four channel remote is required to fi rst set the motor limits before using this transmitter.
- RTS Repeater, C072.044—This repeater plugs into a wall, and it is used to extend range of a transmitter by picking up a signal and
re-emitting it.
- Sunis RTS Light Sensor, C156.117—This is a single-channel interior light sensor. This device can have light sensitivity settings. Adjust
to operate radio motor shades per your lighting needs.
www.draperinc.com
(765) 987-799
9
Page 5 of 124