Operating instructions
Scissor Lift SLX by Draper page 7 of 7
www
.draperinc.com (765) 987-7999
Installing Optional Environmental Air Space Housing
The Environmental Air Space Housing is shipped in pieces, and must be
assembled by the installer. The height of the Environmental Air Space Hous
-
ing is set by punching out the knockouts at the desired locations then using
screws to connect side panels. It is recommended that an access panel be
installed in the ceiling to allow future access. The optional Environmental Air
Space Housing must be installed per instructions to isolate the lift from the
Caution: Be careful when handling Environmental Air Space
Housing Panels. The panels could have sharp edges.
11
11
11
11
11
11
11
7
11
1
3
5
9
3
9
10
2
4
6
3
4
3
8
5
FRONT / BACK
Item Qty Part Number Description
1 C028.544.02SA Frame, SLX Plenum
1 C028.545.07SA Frame, SLX Trim Ring
4 C044.178SA Panel, SLX Plenum Side
4 C044.180SA Panel, SLX Plenum End
2 C044.179SA Panel, SLX Middle End
2 C044.177SA Panel, SLX Plenum Middle Side
1 C095.123SA Cover, SLX Plenum
28 C020.325 Screw, 8-32 x
3
/
8
" Type 1 HWH
40 C018.051 Nut #8-32 Zinc Hex KEPS
12 C013.070 Washer, .188 I.D. x .5 O.D. x .07" TK Nylon Flat
24 C020.112 Screw, 8-32 x
3
/
8
" Type F HWH
Do not use
electrical knockouts
on bottom sections
“other space used for environmental air.” Includes trim ring for ceiling opening.
Attach Environmental Air Space Housing top frame to top of Scissor Lift
SLX with bolts provided.
Install top panel to Environmental Air Space Housing frame.
Attach assembly to overhead structure. Allow clearance between Environ-
mental Air Space Housing top and structure for ease of future access.
Install side and end panels, and trim frame.
Please Note: The factory wiring of 'UP' Limit Switch MUST ALWAYS
be used when SLX is installed in Environmental Air Space Housing
and Optional Ceiling Closure.
Knockouts