Instruction Manual

4. Begining at the Driver's side taillight
pocket, route the harness containing
the
green wire and the 4-Flat down the
opening between the vehicle bumper
and body
g
. Route the 4-Flat harness to
the center of the vehicle. Route harness
containing the
green wire underneath the
vehicle up through the opening between
the vehicle bumper and body to the
passenger’s side taillight pocket.
WARNING
Route the wire being careful to avoid
any hot pipes, heat shields, the fuel tank
or any other points that may pinch or break
the wire.
5. Repeat step 3 for the passenger’s side
using the T-Connector harness end with
the
green wire.
6. Locate a suitable grounding point
near the connector such as the vehicle's
frame or cross member. (Do not drill
into vehicle floor or bed.) Clean dirt and
rustproofing from area. Drill a 3/32" hole
and secure
white wire using eyelet and
screw provided.
CAUTION
Verify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.
WARNING
All connections must be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
Installation Instructions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T
18400-037 Rev. A 03/21/05
ENGLISH
TOOLS REQUIRED:
Screwdriver & Drill (3/32" Drill Bit)
1. Open the tailgate and remove the vehicle’s
taillights. Carefully pry the housings away
from the vehicle, being careful not to break
the alignment tabs
d
.
2. On the driver and passenger sides of the
vehicle, locate the vehicle's taillight wiring
harness
e
. The taillight wiring harness
will have a connection point, near each
taillight housing, matching the ends of
the T-Connector. Separate this connector,
being careful not to break the locking
tabs. All connector surfaces should be
clean and free of dirt
f
.
3. Beginning on the driver’s side, plug
the T-Connector harness containing
the
yellow wire in between the vehicle’s
mating connectors. Be sure that the
T-Connector is fully inserted with
locking tabs in place.
7. On the Driver’s side, mount the
T-Connector Black Box using the
double-sided tape provided. Secure the
remainder of the T-Connector harness
with the cable ties provided, to prevent
damage or rattling and being careful to
avoid any areas that would cut or pinch
the wire.
8. Reinstall the taillight housing
assemblies, positioning the vehicle
wiring harness between the housing
and the vehicle body.
WARNING
Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light:
1 per side (2.1 amps)
• Max. tail lights: (5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
READ THIS FIRST:
Read and follow all instructions carefully
before beginning installation.
LISEZ CECI EN PREMIER:
Lire et suivre toutes les instructions
attenrivement avant le montage.
LEA ESTO PRIMERO:
Lea y siga todas las instrucciones cuida-
dosamente antes de iniciar la instalación.
•
d
•
e
•
g
•
f