Installation Manual
Tighten all ½-13 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 n*m)
Tighten all M8 CL8.8 fasteners with torque wrench to 20 Lb.-Ft. (27 n*m)
Fastener Kit: 24781F
Installation Instructions
Volvo S40
Volvo V50 Wagon
Part Numbers:
77156
24781
60852
Hitch Shown In Proper Position
Wiring Access Location: PC3, PC4
Equipment Required: Pliers
Wrenches: M10, M12, M13, ¾”
Drill Bits: None
Before removing exhaust hanger brackets, bend tabs on brackets down to clear side brackets (see figure 1).
1. Lower exhaust by removing two M8 bolts, each side. Discard bolts.
2. Raise hitch into position. Loosely install M8 x 40mm bolts, 5/16 lock washers and 5/16 flat washers, sandwiching hitch side
bracket between frame rail and exhaust hanger brackets (see figure 1).
3. Install ½” fasteners thru hitch side brackets and vehicle tie-down brackets as shown in figure 1.
Rev. A6-16-0624781NSheet 1 of 3
z 2006 Cequent Towing Products
½-13 Hex NutQty. (2)
4
5/16” Flat WasherQty. (4)
7
½” Lock WasherQty. (2)
3
5/16” Lock WasherQty. (4)
6
¼ X 1 X 2 Spacer Qty. (2)
2
M8 X 1.25 X 40mm Hex BoltQty. (4)
5
½-13 x 1 ¾ Hex BoltQty. (2)
1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2000 LB (908Kg) Max Gross Trailer Weight
200 LB (90.8) Max Tongue Weight
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise
position only.
Drawbar Kit:
3599
Form F206 Rev A 5605