Installation Manual

ManualsBrandsDraw-Tite ManualsAutomotiveDraw-Tite 26102 Dual Cam High Performance Sway Control

INSTALLATION INSTRUCTIONS

Product No.

26102

PLYMOUTH, MI.

DUAL CAM HIGH-PERFORMANCE

SWAY CONTROL

ASSEMBLY:

1. Remove small U-bolt and chain from spring bar if needed. Put the U-bolt in the last chain link, and insert U-bolt ends

through two holes in hanger bracket as shown above. Secure with two lock nuts. Make sure that at least two threads

are showing past the ends of the nuts, pinch the chain if necessary.

2. Adjust Cam Arm Assembly such that the Cam Arm Yoke is approximately centered on the the Cam Arm threads.

Hold position by tightening nuts with finger pressure.

DUAL CAM HIGH-PERFORMANCE SWAY CONTROL PROPERLY INSTALLED

(USE ONLY WITH HIGH-PERFORMANCE WEIGHT DISTRIBUTION OR SPRING BARS WITH INTEGRATED CAM, SEE PAGE 2)

DUAL CAM HIGH-PERFORMANCE SWAY CONTROL COMPONENTS

SET BOLT

1/2-13 X 3.5”

SQUARE HEAD

BOLT

SMALL U- BOLT

INSIDE VIEW OF TRAILER FRAME

HANGER BRACKET

JAM NUT

1/2-13

Flanged head thread

forming screw for

tubular frames

Cap screw, nuts and

lock washers for c-

channel frames

Approximately equal

amount of threads on

either side of yoke.

SPRING BAR & TRUNNION

HANGER BRACKET

BALLMOUNT

FRAME PLATE

CAM ARM YOKE

SNAP-UP

BRACKET

CAM ARM

Summary of content (4 pages)

PAGE 1
INSTALLATION INSTRUCTIONS DUAL CAM HIGH-PERFORMANCE SWAY CONTROL Product No. 26102 PLYMOUTH, MI. DUAL CAM HIGH-PERFORMANCE SWAY CONTROL PROPERLY INSTALLED (USE ONLY WITH HIGH-PERFORMANCE WEIGHT DISTRIBUTION OR SPRING BARS WITH INTEGRATED CAM, SEE PAGE 2) INSIDE VIEW OF TRAILER FRAME FRAME PLATE BALLMOUNT SNAP-UP BRACKET HANGER BRACKET SET BOLT 1/2-13 X 3.
PAGE 2
3. Temporarily clamp frame plate on frame with side having two holes outboard and bottom of frame plate in contact with bottom of frame. Position frame plate for reference at a distance of approximately 18” from center of hitch ball socket for High Performance spring bars. Frame Plate can be positioned in either position shown to accommodate frame interference. (See figure below.) It may be necessary to adjust frame plate position on frame for certain coupler and frame combinations.
PAGE 3
SPRING BAR DETENT HIGH-PERFORMANCE SPRING BAR HOOK-UP: NOTE: Set-up and adjust weight distribution system per Installation Instructions for Weight Distribution. Reference instruction sheet 66006IN for trunnion or 65590IN for round bar styles. 1. Make sure that both cam arm adjustment nuts are backed off sufficiently away from the yoke to allow the cam arm to slide freely through the majority of its adjustment range. 2. Connect trailer to tow vehicle. Tow vehicle and trailer should be in a straight line.
PAGE 4
CAM ARM ADJUSTMENT: 1. Start out towing slowly in a straight line. Make an approximate 20° turn one way, then a 20° turn the other way. Straighten out and drive approximately 100 ft. toward a distant point while sighting down the center of the hood. 2. Check mating of Integrated Cam with cam arm. If not mated squarely, rap button of cam arm with hammer to obtain alignment (see below).