Manual

Installation Instructions
GOOSENECK MOUNTING KIT
Dodge Ram 1500 2002-2008
Short & Long Bed, Excluding Megacabs
6300/8339/83391/83399 GOOSENECK HITCH
Part Numbers:
4438
NOTES:
¾ This rail kit can be used with a 6300, 8339, 83391, 83399 heads only.
¾ Always make sure the ball is fully locked before towing.
¾ Keep the ball and ball pocket well lubricated.
¾ Periodically re-torque all the hitch fasteners.
¾ Check ball, hitch coupler, safety chains and other connections for proper operation
ti t
INSTALLATION
every
ti
me you
t
ow.
Warning:
The tow vehicle manufacturers recommended towing capacities should UNDER NO CIRCUMSTANCES be
exceeded.
Check for adequate clearance between the gooseneck trailer and the rear of the cab and the rear of the truck box
before installing hitch.
All trucks have fuel lines, brake lines and electrical wiring located along the vehicle frame where the rail kit
installs. Carefully examine the location of fuel lines, brake lines and electrical wires before installation and be
t i t t d th h iti i th hit h t B f l h d illi h l tti
cer
t
a
i
n no
t
t
o
d
amage
th
ese w
h
en pos
iti
on
i
ng
th
e
hit
c
h
componen
t
s.
B
e care
f
u
l
w
h
en
d
r
illi
ng
h
o
l
es, cu
tti
ng
sheet metal and tightening fasteners as to not limit the integrity of these systems.
1. To make installation easier, the spare tire and exhaust can be lowered.
2. From underneath the vehicle, install the rear hitch cross member first by placing the right end over the exhaust and
under the front bed support (see Figure 6a). The front and rear cross members are the same.
3
Carefully maneuver the left end up over the wires and brake lines on the inside of the driver
s side frame until the
3
.
Carefully
maneuver
the
left
end
up
over
the
wires
and
brake
lines
on
the
inside
of
the
driver s
side
frame
,
until
the
end of the cross member is over the frame.
Front bed
support
Gas tank
Exhaust
Driver’s side
frame
Vehicle
Forward
Rear bed
support
Passenger’s side
frame
Rear cross
member
z 2008, 2009 Cequent Performance Products
Sheet 6 of 8 4438N 4-3-09 Rev. E
Figure 6a
Rear cross member placement shown