Instruction Manual

ManualsBrandsDraw-Tite ManualsCar58433 ADAPTER KIT

Installation Instructions

ADAPTER BRACKET KIT

Dodge Ram 1500

Part Number:

58433

(Does not fit 5-1/2’ beds)

Equipment Required:

Fastener Kit: 58433F

Wrenches: ¾”, 7/8”, 15/16”

Drill Bits: 1/8”, 9/16”, 5/8”

1-1/8” HOLE SAW

Other Tools: Center Punch, Measuring Tape

WARNING: Under no circumstances do we recommend

exceeding the towing vehicle manufacturers recommended vehicle

towing capacity.

5/8” FLAT WASHER &

LOCK WASHER

5/8 x 3-1/2” CARRIAGE BOLT

RAIL

BRACKETS SUPPLIED WITH

30095 RAIL KIT

5/8” x 3-1/2” HEX

HEAD BOLT

BRACKET

WITH

WELDED

NUTS INSIDE

HAT

½” RIB NECK

BOLTS

1-1/4” TUBE SPACER

5/16” THICK PLATE BETWEEN

RAIL & BED OR UNDER BED

& ABOVE THE BRACKET

CHANNEL

5/8” SERRATED

WASHER & NUT

½” RIB NECK BOLT

½” LOCK WASHER AND NUT

HAT CHANNEL

“L” BRACKET INSIDE HAT CHANNEL EXTENSION

FRONT OF TRUCK

½ x 1-1/2” HEX HEAD BOLT

& LOCK WASHER

HAT

CHANNEL

z2010 Cequent Performance Products

Sheet 1 of 4 58433N 4-26-10 Rev. A

FIG. 1

Summary of content (4 pages)

PAGE 1
Installation Instructions Part Number: ADAPTER BRACKET KIT Dodge Ram 1500 58433 (Does not fit 5-1/2’ beds) Equipment Required: Fastener Kit: 58433F Wrenches: ¾”, 7/8”, 15/16” WARNING: Under no circumstances do we recommend exceeding the towing vehicle manufacturers recommended vehicle towing capacity.
PAGE 2
(Does not fit 5-1/2’ beds) Part Number: ADAPTER BRACKET KIT Dodge Ram 1500 58433 1. Do not install mounting rails over plastic bed liners. Plastic bed liners must be cut out of the way to provide metal to metal contact. Mounting rails may be installed on spray in liners. 2 2. Use only bolts bolts, nuts nuts, and washers supplied to install this kit kit. All bolts are grade 5 and nuts are grade 5 unless otherwise specified. 3.
PAGE 3
Installation Instructions Part Number: ADAPTER BRACKET KIT Dodge Ram 1500 58433 (D (Does nott fit 5-1/2’ 5 1/2’ beds) b d) Position the Rail USE SADDLE/SLIDER/ARCHES TO OUTSIDE BOLT HOLES LOCATE FRONT RAIL 28-3/8” 26-3/8” INSIDE BOLT HOLES 1” z 2010 Cequent Performance Products Sheet 3 of 4 58433N 4-26-10 Rev.
PAGE 4
INSTALLATION OF BRACKETS SHOWN. READY TO DRILL HOLE. CUT HERE, HERE BELOW THE MAIN HAT CHANNEL, TO REMOVE THE LOWER EXTENSION IF MORE ACCESS SPACE IS NEEDED. z 2010 Cequent Performance Products Sheet 4 of 4 58433N 4-26-10 Rev.