User`s guide

Vigor2710 Series User’s Guide

Modulation – Drop down the list to choose a proper modulation

for the router.

WAN Connection

Detection

Such function allows you to verify whether network connection

is alive or not through ARP Detect or Ping Detect.

Mode – Choose ARP Detect or Ping Detect for the system to

execute for WAN detection.

Ping IP – If you choose Ping Detect as detection mode, you have

to type IP address in this field for pinging.

TTL (Time to Live) – Displays value for your reference. TTL

value is set by telnet command.

RIP Protocol Routing Information Protocol is abbreviated as RIP（RFC1058）

specifying how routers exchange routing tables information. Click

Enable RIP for activating this function.

Bridge Mode If you choose Bridged IP as the protocol, you can check this box

to invoke the function. The router will work as a bridge modem.

WAN Backup Setup 3G USB Modem – If you install a 3G USB modem on the router,

please Enable the Dial Backup Mode to perform file backup via

USB device. After choosing Enable, please click the 3G USB

Modem link to access into the following page for configuring

detailed settings.

PPP Client Mode - Click Enable to activate this mode for WAN2.

SIM PIN code - Type PIN code of the SIM card that will be used

to access Internet.

Modem Initial String - Such value is used to initialize USB

modem. Please use the default value. If you have any question,

please contact to your ISP.

APN Name - APN(Access Point Name) is provided by your ISP

for identifying different access points. Simply click Apply to apply

such name. Finally, you have to click OK to save the setting.

Apply – Activate the function of identification.

Modem Dial String - Such value is used to dial through USB

mode. Please use the default value. If you have any question,

please contact to your ISP.

PPP Username - Type the PPP username (optional).