User`s guide

Vigor3100 Series User’s Guide
104
replaced by the prefix number for calling out through the
specific VoIP interface. Take the above picture (Prefix Table
Setup web page) as an example, the prefix number of 03 will be
replaced by 8863. For example: dial number of “031111111”
will be changed to “88631111111” and sent to SIP server.
OP Number The front number you type here is the first part of the account
number that you want to execute special function (according to
the chosen mode) by using the prefix number.
Min Len Set the minimal length of the dial number for applying the
prefix number settings. Take the above picture (Prefix Table
Setup web page) as an example, if the dial number is between 7
and 9, that number can apply the prefix number settings here.
Max Len Set the maximum length of the dial number for applying the
prefix number settings.
Interface Choose the one that you want to enable the prefix number
settings from the six pre-saved SIP accounts.
3
3
.
.
9
9
.
.
2
2
S
S
I
I
P
P
A
A
c
c
c
c
o
o
u
u
n
n
t
t
s
s
In this section, you set up your own SIP settings. When you apply for an account, your SIP
service provider will give you an Account Name or user name, SIP Registrar, Proxy, and
Domain name. (The last three might be the same in some case). Then you can tell your folks
your SIP Address as in Account Name@ Domain name
As Vigor VoIP Router is turned on, it will first register with Registrar using
AuthorizationUser@Domain/Realm. After that, your call will be bypassed by SIP Proxy to the
destination using AccountName@Domain/Realm as identity.