System information

Vigor3900 Series Quick Start Guide
5
2
2
.
.
I
I
n
n
s
s
t
t
a
a
l
l
l
l
i
i
n
n
g
g
Y
Y
o
o
u
u
r
r
R
R
o
o
u
u
t
t
e
e
r
r
This section will guide you to install the router through hardware connection and configure the
router’s settings through web browser.
Before starting to configure the router, you have to connect your devices correctly.
1. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of Vigor3900s.
2. Connect the other end of the cable (RJ-45) to the Ethernet port on your computer (that
device also can connect to other computers to form a small area network). The LAN LED
for that port on the front panel will light up.
3. Connect a server/modem/router (depends on your requirement) to any WAN port of
Vigor3900 with Ethernet cable (RJ-45). The WAN1 (to WAN4) LED will light up.
4. Connect the power cord to Vigor3900’s power port on the rear panel, and the other side into
a wall outlet.
5. Power on the device by pressing down the power switch on the rear panel. The PWR LED
should be ON.
6. The system starts to initiate. After completing the system test, the ACT LED will light up
and start blinking.
Below shows an outline of the hardware installation for your reference.