User`s guide

VigorIPPBX 3510 Series User’s Guide
110
Mode
None - No action.
Add - When you choose this mode, the Operand number will
be added before the prefix number for calling out through the
specific route.
Strip - When you choose this mode, partial or the whole
prefix number will be deleted according to the Operand
number. Take the above picture (Prefix Table Setup web
page) as an example, the Operand number of 886 will be
deleted completely for the prefix number is set with 886.
Replace - When you choose this mode, the Operand number
will be replaced by the prefix number for calling out through
the specific VoIP interface. Take the above picture (Prefix
Table Setup web page) as an example, the prefix number of
03 will be replaced by 8863. For example: dial number of
“031111111” will be changed to “88631111111” and sent to
SIP server.
Operand Number
The front number you type here is the first part of the
account number that you want to execute special function
(according to the chosen mode) by using the prefix number.
Min Len
Set the minimal length of the dial number for applying the
prefix number settings. Take the above picture (Prefix Table
Setup web page) as an example, if the dial number is
between 7 and 9, that number can apply the prefix number
settings here.
Max Len
Set the maximum length of the dial number for applying the
prefix number settings.
Trunk
Choose the one that you want to enable the match prefix
settings from the saved SIP accounts. Please set up one SIP
account first to make this route available. This item will be
changed according to the port settings configured in IP
PBX>>PBX System>>Phone Settings and IP PBX>>
Trunks >>SIP Trunk.