User`s guide

VigorIPPBX 3510 Series User’s Guide
29
IP Address Display the IP address of the LAN interface.
TX Packets Display the total transmitted packets at the LAN interface.
RX Packets Display the total number of received packets at the LAN interface.
WAN 1/2 Status
Enable Display if such WAN interface is enabled or not.
Line Display the physical connection (Ethernet) of this interface.
Name Display the name set in WAN page.
Mode Display the type of WAN connection (e.g., PPPoE).
Up Time Display the total uptime of the interface.
IP Display the IP address of the WAN interface.
GW IP Display the IP address of the default gateway.
TX Packets Display the total transmitted packets at the WAN interface.
TX Rate Display the speed of transmitted octets at the WAN interface.
RX Packets Display the total number of received packets at the WAN interface.
RX Rate Display the speed of received octets at the WAN interface.
Note: The words in green mean that the WAN connection of that interface is ready for
accessing Internet; the words in red mean that the WAN connection of that interface is not
ready for accessing Internet.
2
2
.
.
5
5
S
S
a
a
v
v
i
i
n
n
g
g
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
Each time you click OK on the web page for saving the configuration, you can find
messages showing the system interaction with you.
Ready indicates the system is ready for you to input settings.
Settings Saved means your settings are saved once you click Finish or OK button.