Installation guide

VigorIPPBX 3510 Quick Start Guide
2
1
1
.
.
1
1
P
P
a
a
n
n
e
e
l
l
E
E
x
x
p
p
l
l
a
a
n
n
a
a
t
t
i
i
o
o
n
n
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
f
f
o
o
r
r
L
L
E
E
D
D
LED Status Explanation
On The router is powered on. PWR (Power)
Off The router is powered off.
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is not ready or failed.
On The WAN connection is ready. WAN
Blinking It will blink while transmitting data.
On CDR utility has been installed and is recording. CDR
Off CDR utility has not been installed and is unable to
record.
On A USB device is connected and active. USB
Blinking The data is transmitting.
MSF Blinking
Storage (NAND flash or USB disk) is full.
VPN On The VPN tunnel is active.
CSM On The profiles of CSM (Content Security Management)
for IM/P2P, URL Content Filter, Web Content Filter
application is enabled from Firewall >> General
Setup. (These profile can be established under CSM
menu).
QoS On The QoS function is active.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 100Mbps.
LAN 1/2/3/4*
Right LED
(Green)
Off The port is connected with 10Mbps.
On The port is connected.
Off The port is disconnected.
Left LED
(Green)
Blinking The data is transmitting.
On The port is connected with 100Mbps.
WAN1/2*
Right LED
(Green)
Off The port is connected with 10Mbps.
* LAN 4 and WAN 2 share the same connector.