Instruction Manual

3
TO USE:
1. Before running this appliance, it is important that all bottles, bottle parts and/or
other accessories are clean. They must be washed, rinsed and empty.
2. Position the appliance on a at surface and out of reach of children where it cannot
be knocked or moved during operation. Remove the lower rack, tray, and lid from
the base.
3. Fill the measuring cup to 110 mL with bottled water and pour the water
ONTO THE STAINLESS STEEL HEATING PLATE in the base.
CAUTION: DO NOT EXCEED the recommended amount of water.
NOTE: For best performance, use non-mineral bottled water and descale monthly.
4. Place the lower rack on the base and arrange bottles with the opening facing
down over the posts of the lower rack. Place the bottle accessories (e.g. nipple/teat,
collar, cap, etc.) on the tray. Always replace lower rack on base before turning the
sterilizer on.
NOTE: If using Dr. Brown’s bottles and parts, see Figure A through Figure H on
page 6 for suggested layout options. Both narrow and wide-neck bottles are shown.
PARTS:
A. Lid
B. Tray
C. Removable Handle
D. Lower Rack
E. Base
F. Control Panel
G. Filter Cover
H. HEPA Type Filter
I. Measuring Cup
CONTROL PANEL:
Power
Sterilize Only
Dry Only
Automatic
Sterilize/Dry
8
A
1234567
D
C
B
C
A
D
B
5 3 16 248 7
1
THIRD ANGLE
PROJECTION
HANDI-CRAFT COMPANY
4433 FLYER AVE. ST. LOUIS MO. 63116, USA
3D
INTERPET PER ASME Y14.5-1994
OTHER HANDI-CRAFT ENGINEERING
STANDARDS MAY APPLY
NO PLACE:
ONE PLACE:
TWO PLACE:
THREE PLACE:
ANGLE:
ANGLE:
2.5
0.5
0.25
0.13
0.5
0.25
X
.X
.XX
.XXX
X
.X
THIS DRAWING AND RELATED 3D CAD DATA
CONTAINS PROPRIETARY INFORMATION
THAT ARE THE PROPERTY OF
HANDI-CRAFT CO. AND ARE NOT TO BE
COPIED OR USED WITHOUT THE
PERMISSION OF HANDI-CRAFT CO.
ENG APPR.
MFG/Q.A APPR.
SOLIDWORKS
DESIGN UNITS: MILLIMETERS
TOLERANCES UNLESS NOTED:
DRAWN
TITLE:
SIZE
D
DWG. NO.
REV.
SCALE: 1:2 SHEET 1 OF 1
DO NOT SCALE DRAWING
STERILIZER EXPLODED
RBW
10JUL19
MATERIAL
A
B
C
D
E
F
G
I
H