User Manual

-8-
1.3.1 Explanation Front Panel
1. CI-Slot
Plug in here any CI- Module of your choice. Please press the release button right next to the CI-Slot to remove
a module.
2. CD- or DVD-Drive (optional)
You can insert a slimline CD- or DVD-Drive into this slot. Slimline drives are used in notebooks for example.
The drive is not part of packaging contents.
3. Smartcard reader
Insert your Dreamcrypt Smartcard with the golden chip facing down and forward into one of the two Smart-
card reader slots. Dreamcrypt is a registered trademark of Dream-Multimedia.
4. Compact Flash Slot
The Compact Flash Slot is meant to hold a Compact Flash Module.
5. SD/MMC Slot
The SD/MMC Slot is meant to hold a SD/MMC-Card used in digital cameras for example.
6. USB 2.0 Port
The USB 2.0 port is meant to connect USB 2.0 compliant devices. The extend of the supported devices
depends on the software and is always under further development.
7. Channel up/down
Using the channel-up and -down buttons you can switch the channels directly on your Dreambox.
8. OLED-Display
The OLED-Display shows all major information.
9. Remote control sensor
The remote control sensor receives the infrared signals of the Dream Remote Control.
10. Power button
The Power-Button switches your Dreambox on and off.
1.3.2 Explanation rear panel
1. Mains switch
The main power switch shuts off power from your Dreambox.
!!! IMPORTANT !!! Before opening the device, always pull the power plug !!! IMPORTANT !!!
2. Mains connection
Plug the power cable into the main power socket. You must not connect the power plug to anything other
than a socket that supplies 110V/60Hz or 230V/50Hz.