Operation Manual

9. With the Navigation-Buttons (JI) choose the desired Satellite.

10. With the Navigation-Buttons (NH) choose the option “Port B”.

11. With the Navigation-Buttons (JI) choose the desired Satellite.

12. Press the OK-Button to save this settings.

Make sure you know which satellite is connected to which input on the Toneburst switch. If you do not ﬁnd

any services in the transponder scan later, exchange the two satellites in this list and try again.

7.1.3 Two satellites via DiSEqC A/B

Use this type of conﬁguration if you want to receive two satellites from one Twin Universal or Quad Uni-

versal LNB. It does not matter if you use one or two dishes to achieve this.

In this case the LNBs are connected to a so-called Multiswitch from which the signal is via coax cabled to

the satellite receivers (Dreamboxes) in your household.

Two satellites via DiSEqC A/B

Follow this steps:

1. Press the Menu-Button to open the main OSD menu.

2. With the Navigation-Buttons (NH) choose the option “Setup” and press the OK-Button.

3. With the Navigation-Buttons (NH) choose the option “Service searching” and press the OK-

Button.

4. With the Navigation-Buttons (NH) choose the option “Tuner conﬁguration” and press the OK-

Button.

5. With the Navigation-Buttons (NH) choose the option “DVB-S2 Tuner” and press the OK-Button.

6. With the Navigation-Buttons (NH) choose the option “Mode”.

7. With the Navigation-Buttons (JI) choose the option “DiSEqC A/B”.

8. With the Navigation-Buttons (NH) choose the option “Port A”.