Installation & Assembly

To Install, place the gate in the opening so that the bottom of the Gate Frame is completely flat on the

floor (3A), and it is perpendicular to the openings and the floor (3B & 3C).

Then fasten the Mounting Cups to the wall with screws or double-sided adhesive tape (4A).

Note: Ensure that they are aligned vertically, so that the Mounting Cups at the top are

directly above the ones at the bottom (4B).

For use on stairs (5A & 5B).

Top view of gate

Side view of gate

floor floorfloor

Fasten Mounting Cups to the wall with

screws or double-sided adhesive tape.

G x 4J x 4

If the gate is used at the

bottom of the stairs to

prevent the child from

climbing up the stairs, it

must be placed on the

lowest stair.

If the gate is to be used

at the top of the stairs to

prevent the child from

falling down the stairs, it

must not be placed on

any stair below the level

of the top stair.

Bottom of stairs

Top of stairs

G x 4J x 4

Partially slide the Bolts with Rubber Pads and Tension Knobs outwards (6A) from the Gate Frame /

Extension Frames into Mounting Cups (6B).

Screw in Mounting Cups

when using gate on stairs

6A 6B