Installation & Assembly

Tighten inward

Tighten inward and

align the arrows

Tension

Knob

Gate

Frame

Keep this gap about 1mm

Tighten both of the bottom Tension Knobs (7A) by

turning them clockwise at the same time (7B & 7C).

NOTE: Make sure the bottom of the gate frame

remains completely flat on the floor.

Next, tighten both of the Tension Knobs at the top at

the same time by turning them clockwise (7C).

Tighten

inward

Note: When first installing, the gate will have this gap. This is

normal and will disappear when gate is completely installed.

Tighten the Tension Knobs until the two Arrows,

located on the Upper Locking Set and on the

Right Upper Corner, align horizontally (8A).

When correctly tightened, the distances

between Tension Knobs and Rubber Pads

should be equal (8B, 8C).

Distance should be equal