User manual

Chapter 11

TV-Mode setup

With the Dreambox remote control you have the possibility to control the dreambox and your tv device

with only one remote control. In order that your tv device reacts to the signals of the remote control, you

have to program it before.

There are 3 options for programming the rcu:

1. Programming with Code

2. Programming by Learning function

3. Programming by Scan function

Please read the steps of each programming method carefully, before you proceed.

Programming with Code

In this programming method a manufacturer-speciﬁc code is used (refer to device list on www.dreambox.de).

1. Press the OK-Button and the TV-Mode-Button for ˜ 3 seconds.

2. Enter the desired 3-digit Code 000-999 with the Numeric-Keypad. Now press the Mute- or Volume

Button in order to check if the tv device responds to the just entered code. If there is no response,

please try it with the next code from the list, according to the steps above.

3. If none of the given codes is suitable, please proceed with the chapter “Programming by Scan function”.

If no code is entered within 6 seconds or the TV-Mode-Button is pressed, the remote control will

exit the programming mode automatically.

Programming by Scan function

In this programming method the dreambox rcu sends every second another shutdown-code to the tv device,

until the tv shuts oﬀ. Use this method of programming, if the Programming with Code wasn’t successfully,

or the vendor of your speciﬁc tv device isn’t listed.

1. Press the OK-Button and the TV-Mode-Button for ˜ 3 seconds.

2. Enter 777 with the Numeric-Keypad, in order to start the scan mode and point the rcu (with

ir-sensor) into the direction of your tv device.