Installation Guide

UNIDOOR-X (STYLE M) manual Ver 2 11/2016

Door

1”

Around Bottom sweep

measure

Handle side of door

Fig 28

Fig 27

Panel

22. Measure the bottom of the Door Glass (#01) from

side to side to determine the actual width of the door.

Cut the Bottom Anti-Water Strip (#07) to the size of

your measurement and notch 3/8” of the inner side of the

Bottom Anti-Water Strip (#07) as shown in Fig 27.2.

Press the Bottom Anti-Water Strip (#07) onto the

bottom edge of the Glass Door (#01).

NOTE: Make sure the Bottom Anti-Water Strip (#07) is

flush to the vertical edge of the handle side of the Door

Glass (#01). (Fig 27)

23. To install the Flanged Anti-Water Strip (#33), take three measurements :

• from the top edge of the Door Glass (#01) to the top of the center portion of the top Hinge (#06)

(see Fig 28.1 for an example to use for taking all three measurements)

• from the bottom of the center portion of the top Hinge to the top of the center portion of the

bottom Hinge (#05)

• from the bottom of the center portion of the bottom Hinge (#05) to the threshold

Cut the Flanged Anti-Water Strip (#33) according to these measurements. Notch the cut strips to

slide them into the hinges and around the installed Bottom Anti-Water Strip (#07) to cover the

space between both glass panels. Open the door and press the cut strips onto the vertical edge of

the Door Glass (#01) so they will overlap the panel glass. (Fig. 28)