Installation Guide

“UNIDOOR PLUS (STYLE F)” Ver.1 Rev 4 06/2016
9
3. Slip the cut U-channel 2 (44”, bottom profile) (29)
and uncut U-channel 1 (76”, wall profile) (09) onto
the Stationary glass (11) in the shown locations.
With the door open place the Stationary glass on
threshold opposite of door. Adjust the Stationary
glass and U-channel 1 (wall profile) against the
wall to compensate for any out of plumb conditions
ensuring that the Stationary glass is level vertically
and U-channel 1 is flush with the wall.
Mark the U-channel 2 (bottom profile) end
opposite of the wall at the exposed vertical glass
edge.
Remove the U-channel 2 (bottom profile). Leave
the U-channel 1 (wall profile) on the Stationary
glass. Set the Stationary glass aside.
Cut the U-channel 2 (bottom profile) at the mark.
Slip the U-channel 2 (bottom profile) back onto
the Stationary glass.
See Fig. 4 for details.
4. Press the Anti-Water strip (inline panel) (19) on the
vertical edge of the Stationary glass (11).
Align the Stationary glass with the threshold Door
mark and then close the Door. If needed adjust the
position of the Stationary glass so that the Anti-
water strip makes tight contact to the Glass Door
from top to bottom.
NOTE: The top of the Stationary glass must be
leveled with the Glass door.
Outline the position of the Stationary glass along
the inside edge of both U-channels on the wall and
threshold base.
Mark the U-channel 1 (wall profile) at the top
horizontal glass edge.
See Fig. 5 for details.
outside
inside
Door
mark
Stationary
glass
Align Stationary glass
with Door mark.
inside
wall
inside
wall
outside
inside
inside
outside
Door
Stationary
glass
Fig. 5
1
3
5
2
4
6
wall
inside
Stationary
glass
U-channel 2
U-channel 1
inside
Fig. 4
1
3
5
2
4
6