Installation Guide

ManualsBrandsDreamLine ManualsAlcove Shower DoorsUnidoor-X 51-1/2 in. to 52 in. x 72 in. Frameless Pivot Shower Door in Oil Rubbed Bronze

Installation steps

8UNIDOOR-X Style M Ver 1 Rev 6 06/2016

inside

wall

inside

U-channel 2

U-channel 1

inside

wall

inside

Stationary

glass 2

wall

inside

5 6

Fig 1

2. Mark the end of the U-channel 2 (#29)(bottom

profile) opposite of the wall at the exposed vertical

glass edge.

•Mark the top of U-channel 1 (#09) (wall profile) flush

with the top of the glass (Fig 1 .6) .

•Mark the position of both u-channels on the wall and

threshold from inside the shower area (Fig 1.5).

See Fig. 1 for details

1. Trim the 0.5mm PVC glass spacer (#34)

into several 2” pieces. Insert three to four 2”

pieces of the 0.5mm adjustment spacers

(#34) into the U-channel 2 (#29) (bottom

profile). These are used as setting blocks to

protect the bottom of the glass.

•Slip the U-channel 2 (#29) (bottom profile) and uncut

U-channel 1 (#09) (76” wall profile) onto the Hinge

panel glass (#32) as shown.

•Place the Hinge panel glass (#32) with the U-channels

1 & 2 onto the threshold (Fig 1.2).

•Adjust the Hinge Panel glass (#32) and U-channel 1

(#09) (76”, wall profile) against the wall ensuring that

the Hinge Panel glass (#32) is level vertically and

U-channel 1 (#09) is flush with the wall.

•Make certain that your U-channel 2 (#29) is parallel to

the outside of your threshold. Use a level while

adjusting your glass to verify that it is plumb.

See Fig. 1 For details

NOTE: The following shower door installation instructions

should be used as a general guide and prerequisite to the

installation of the UNIDOOR Style M, M1, M2, M3, M4, M5,

M6 and L1 models. Before you begin the installation,

please check your finished opening size and model dimen-

sions to ensure proper placement of the Hinge panel glass

(#32) and Glass door (#01). Specific size information can be

found on our website at: DreamLine.com.

NOTE: There is a top and a bottom to the hinge panel glass

(#32): the top hinge cutout is 7-7/8” to center, the bottom

hinge cutout is 8-3/8” to center. This glass must be installed

correctly for a successful installation.

NOTE: The 24” Hinge Panel Glass is the primary example shown

throughout this installation manual. Use the following

installations procedures when installing the 6” Hinge Panel

glass with the exclusion of the L-Bracket (#35). See page 14 for

more information about the L-bracket installation.

Style “M” 6” & 24” In-Line Panel and Shower Door Installation