Installation Guide

15
UNIDOOR-X (STYLE M) manual Ver 2 11/2016
Fig 13
Fig 14
Metal File
Plumb line
Out-of-plumb
at the bottom
<Less than 90°
A
Plumb line
**If the wall is out-of-plumb at
the bottom, measure that
dimension as (A) and add
it to the length of the U-channel
( +1/4” max):
Finished cut length= 24” + A
OR
Glass Width + 3/16” + dimension A
= Finished cut length
U-Channel 1
U-Channel 2
L
L
Installation steps for 24” hinge panel glass with L-Bracket
10. Cut the vertical U-channel 1 (#09) to 71”. (Fig 13)
TIP: Use a metal file to remove any burrs from the cut
end of the U-channels before placing them onto the
glass.
NOTE The vertical U-channel for the Hinge Panel glass
will accomodate up to 1/4” for out-of-plumb.
Do not exceed this amount.
11. Cut the bottom U-channel 2 (#29) to 24”
(see note** below). (Fig 14)