Installation Guide

© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
10 LUMEN shower door manual Ver 1 Rev 2 09/2018
©2018 DreamLine. All Rights Reserved
2
Position the tape so that it does not
interfere with aligning the magnetic strips
Fig 6
Fig 5
Loosen, but Do Not remove the two smaller bolts on
the hinge to allow enough space to install the door
glass without fully disassembling the hinges.
3
inside
re-tighten
the small
bolts
1
2
3
rail
ush
with
top
of
glass
apply a thin bead of
silicone into the Strike
Rail
!
!
DO NOT REMOVE THE TWO
SMALLER HINGE BOLTS: Only loosen
these smaller bolts enough to allow
the door glass to slide into the hinge.
*Insert the plastic sleeves
into the holes in the door
glass before attaching the
door glass to the hinges.
1
inside
DO NOT
REMOVE
THESE
BOLTS
remove
the
large
bolts
and
sleeves
5. The Hinge Assemblies (#04) are
pre-attached to the Hinge Profile (#02).
Remove the large allen bolts and protective
sleeves from the hinges. (Fig 5.1)
Loosen the smaller allen bolts on the hinges
to create enough space to slide the glass into
the hinges.
*Place the protective sleeves into the hinge
holes on the Door Glass (#06).
Align the holes in the Door Glass (#06) with
the holes in the hinges. Install the large bolts
through the protective sleeves in the hinge
holes and tighten. Re-tighten the small bolts
on the hinges to secure the Door Glass (#06).
(Fig 5)
6. Clean the edge of the Door Glass (#06)
prior to attaching the Strike Rail (#07).
Apply a thin bead of silicone into the Strike
Rail (#07) and attach it to the strike edge of
the Door Glass (#06). Make certain that the
Strike Rail (#07) is tight to the glass and
flush with the top and bottom edges. Secure
the rail in place with some painter’s tape until
the silicone fully cures. (Fig 6)