Installation Guide

12 LUMEN shower door manual Ver 1 Rev 2 09/2018

Fig 8

Fig 7b

strike profile

wall profile

door

strike rail

Adjust the Strike profile to

make sure that the magnets

make full contact from top to

bottom.

The 1/2” shims should only be removed after the

Hinge profile and Wall profile are screwed together

Hinge side as viewed from inside the shower

ST4.2x10

washer

1/8”

(3.2mm)

inside

top

Left hinged door shown as an example

13(x1)

7b. Check the door for level. Adjust the Hinge Profile (#02) as

necessary. From inside of the shower, drill an Ø1/8” hole

through the predrilled hole at the top of the hinge-side Wall

Profile (#01) and secure the Wall Profile (#01) to the hinge

profile using an ST4.2 x 10mm Pan Head Screw (#13) and

Washer (#14). This will provide some support for the door until

the remaining ST4.2 x 10mm (#13) screws are installed in Step

#12, after the Strike side profiles are installed. This screw may

need to be repositioned at that time depending on the

finished opening conditions. (Fig 7b)

8. Position the Strike Profile (#09) and Wall Profile (#10) against the wall. Close the door and use a

tape measure to align the Door Glass (#06) parallel to the front edge of the threshold. Align the Strike

Profile (#09) with the Strike Rail (#07) on the edge of the door. Check the strike-side Wall Profile

(#10) for plumb, but make sure that the magnets align. Adjust the Strike Profile (#09) within the Wall

Profile (#10) for overall width or out-of-plumb.

Mark the position of the Wall Profile (#10) on the wall from inside the shower. (Fig 8)