Installation Guide

Installation steps

7 LUMEN shower door manual Ver 1 Rev 2 09/2018

Fig 1

Fig 2

wall

threshold

Ø5/16”

(8mm)

Threshold must be level

Measure the nished opening

outside

Left-Swing door installation shown as an example

1. Meaure the finished opening width at the top (at model height),

middle and bottom. Check the threshold for level and the walls for

plumb. (Fig 1)

Note that this model can adjust up to 1/2” per side for out-of-plumb

conditions or 1” for overall width within the model size.

2. Install the Wall Profile (hinge side) (#01) first. Position

the Wall Profile (hinge side) (#01) onto the threshold

and against the wall and plumb with a level. Mark the

position of the Wall Profile (hinge side) (#01) on the wall

(from inside of the shower) and mark the holes for drilling.

Remove the Wall Profile (hinge side) (#01) and drill

Ø5/16”(8mm) holes. Insert the Wall Anchors (#16)

into the holes. (Fig 2)