Installation Guide

Preparation

1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece

count with the packing slip. After opening all boxes and packages read this introduction carefully.

Check that all of the necessary parts are included in the package by checking off the components on

the “Detailed Diagram of Shower Door Components”. If the unit has been damaged, has a finishing

defect, or has missing parts, please contact our customer support department within 3 business days

of the delivery date. Please note that DreamLine

will not replace any damaged products or

missing parts free of charge after 3 business days or if the product has been installed. Contact

DreamLine

if you have any questions, and please provide an order number, job name or other proof

of purchase to help identify the original order.

2. Please note that you should consult your local building codes with questions on installation

compliance standards. Building and plumbing codes may vary by location, and DreamLine

not responsible for code compliance standards for your project and will not accept any returns.

3. If this unit is going to be installed in a new construction, please install all of the required plumbing

and drainage before installing the shower. Use a competent and licensed (if required by local code)

plumber for all plumbing installation

4. Make sure that prior to beginning the installation, the surfaces are leveled and solid and will be able

to support the total weight of the unit. Also make sure the walls are at right angles. Irregular

installation surface level, radius corners or improper angle of side walls will result in serious problems

for your installation. Note that some adjustments and drilling will be necessary during the installation

process.

5. Protect all primary surfaces of the product during installation. Never set the glass down directly

onto a tile floor. Leave corner protectors in place until necessary to remove them. Always use a piece

of wood or cardboard to protect the bottom edge and corners of the glass prior to and during

installation.

6. This unit must be installed upon a level finished threshold and against finished walls.

7. This model has 3/8” of adjustment for out-of-plumb wall conditions using the adjustable wall

profiles Make sure that the walls are within this range before proceeding with the installation.

8. Professional installation recommended.

NOTE: DO NOT attach the handle to the door glass or the towel bar to the panel glass

until instructed.

DO NOT use the handle or towel bar to lift the glass during installation. This may result in

damage to the glass and/or serious injury. Always use an assistant or a professional grade

glass suction cup when handling heavy glass.

PRISM shower enclosure manual Ver 1 Rev 4 05/2018