Installation Guide

“PRISM” Ver.1 Rev.3 08/2015

Shower Enclosure Installation

1. Draw the line on the wall according to your Shower

Enclosure model size.

Place the Wall profiles (02) onto the Shower base or

threshold against the finished wall and level it vertically.

See Fig. 1 for details.

Enclosure assembly measurements：

Fig. 1

2. Make sure the Wall profile (02) is absolutely vertical.

Mark the drilling holes on the wall through the predrilled

holes in the Wall profile.

Drill the holes in the wall using Ø 5/16” drill bit and insert

the Wall anchors (08).

Run a bead of Waterproof silicone along the Wall profile.

Fasten the Wall profile to the wall using the Round head

screw ST4.2×40 (11).

See Fig. 2 for details.

Fig. 2

Measure from the finished corner to the inside edge of wall profile as shown:

Model No.

SHEN-GL2101-343410

33 7/16”

SHEN-GL2101-363610

35 7/16”

SHEN-GL2101-383810

37 7/16”

SHEN-GL2101-404010

39 7/16”