Installation Guide

“PRISM” Ver.1 Rev.3 08/2015
9
7. Mount top and bottom Pivot
assemblies (07) to the Pivot bars
(05) using Hex socket bolts
M8×12 (16).
Remove the back fastener from the
Pivot assemblies. Set the Glass
door (04) so the holes are aligned.
Make sure the vinyl gaskets are in
between the glass and the metal
parts. Secure the back fastener with
the provided bolt.
See Fig. 9 for details.
Fig. 9
8. Push the Flanged anti-water strip (14)
to the vertical edge of the Glass door
(04) to seal between the door and the
Stationary glass (03).
Push the Bottom anti-water strip (13)
to the bottom edge of the Glass door.
Push the Magnetic strips (12) to the
vertical edges of the Glass door and
the Stationary glass.
Install the Handle (06) to the Glass
door.
See Fig. 10 for details.
Fig. 10
1
2
3
1
2
3
4
Door
Door
Inside
Inside
NOTE: Trim off the excess Bottom anti-
water strip and attach a 1” piece on the
opposite side of the bottom pivot.