Installation Guide

10PRISM shower enclosure manual Ver 1 Rev 4 05/2018

Fig 4a

Fig 4b

Fig 5a

Fig 5b

Be sure to install both of the Pivot Bars (#05) with the pivot

holes on the correct side for the desired swing of the door.

inside

pivot holes

Left-hand door installation shown as an example

5. Examine the Pivot Bars (#05) and notice that there are

holes for the top and bottom pivot assemblies on one end.

Attach the top and bottom Pivot Bars (#05) (with the pivot

holes on the correct side for the swing of the door) through

the holes in the Panel Glass (#03).

Put the clear Vinyl Gaskets (#15) between the Pivot Bars

(#05) and the Panel Glass (#03) to prevent glass-to-metal

contact. Use the Hex Socket Bolts M8×25 (#17) and

Decorative Washer (#18) to attach the Pivot Bars (#05) to

the Panel Glass (#03). (Fig 5a and Fig 5b)

NOTE: Use caution not to bang the

panel glass on the threshold.

4. Be sure the Panel Glass (#03) and Glass Profiles (#01) have had time to set up before handling.

Insert each assembled Panel Glass (#03) and Glass Profile (#01) into the installed Wall Profiles (#03)

and check the panels for plumb. If necessary, adjustments can be made by moving the Glass Profiles

(#01) within the Wall Profiles (#03). Use caution not to pull the Panel Glass (#03) out of the Glass

Profiles (#01). (Fig 4a and Fig 4b)