Installation Guide

“PRISM” Ver.1 Rev.3 08/2015

3. Apply clear silicone along the inner channel of the

Glass profile (01) and push the Stationary glass (03)

inside the channel.

Slide the Stationary glass assembly into the groove

of the Wall profile (02).

NOTE: The small holes on the Stationary glass

should be away from the wall.

NOTE: If you have difficulty sliding the Glass profile

over the Stationary glass, you can slightly tap on the

Glass profile with a rubber mallet and a piece of wood.

Please do not strike directly on the profile or on the

edge of the glass panel.

See Fig. 3 for details.

Fig. 3

4. Insert the assembled Stationary glass into the Wall profile (02).

See Fig. 4 and Fig. 5 for details.

Fig. 4