Installation Sheet

Installation steps
©2018 DreamLine. All Rights Reserved
8PRISM shower enclosure manual Ver 1 Rev 4 05/2018
NOTE: If there is difficulty sliding the Glass
Profiles (#01) on to the Panel Glass (#03),
lightly tap on the Glass Profile with a rubber
mallet and a piece of wood.
Do Not strike the profile directly with a hammer.
!
Attach the Glass Profile(s) (#01)
to the edge opposite of the holes.
Fig 1b
Fig 1a
1
4 5 6
2
3
NOTE: If time allows, do not handle the
panel glass until the silicone holding
the glass profile has fully cured. This
prevents the glass profile from slipping
out of postion during installation or
adjustment.
Make sure that the glass profile
is flush/even with the top and
bottom of the panel glass.
flush
flush
!
1. Apply clear 100% silicone into the Glass
Profiles (#01) and firmly attach the Glass
Profiles (#01) to the correct edge* of the Panel
Glass (#03).
Carefully set the Panel Glass (#03) assemblies
aside. (Fig 1a)
*NOTE: The holes (for the pivot bar) should be
on the opposite edge from the glass profile.
(Fig 1b)