Installation Guide

11PRISM shower enclosure manual Ver 1 Rev 4 05/2018

Pivot

Assemblies

(#07)

Fig 7

Fig 6

1 2 3

Ø1/8”

wall

inside

wall

inside

Left-hand door installation shown

inside

door

panel

bottom

Tip: Attach both pivot assemblies to the pivot bars as shown in Step 6 and install the door

glass to the Pivot Assemblies OR attach the bottom pivot assembly to the bottom pivot

bar and the top pivot assembly to the door glass and install the door.

Before installing the door glass, attach the longer Magnetic Strike Vinyl (#12) to the strike edge

of the Panel Glass (#03)

(the panel that the door will close against) to protect the edge of the

door glass from making contact with the panel glass during installation. (See Step 8, Fig 8.4)

inside

7. Make any final adjustments using the adjustable wall profiles so that the door opening is square.

Drill through the predrilled holes in the Wall Profiles (#02) into the first layer of the Glass Profiles

(#01) using an Ø1/8” drill bit.

Use the Pan Head Screws ST4.2×10 (#10) and washers to secure the Glass Profiles (#01) inside the

Wall Profiles (#02). Cover the screws with the Decorative Covers (#09). (Fig 7)

6. The pivot assemblies are paired: one rotates CW and one rotates CCW. Take note to install the

Pivot Assemblies (#07) to the top and bottom Pivot Bars (#05) so that the door will swing out.

Attach the top and bottom Pivot Assemblies (#07) to the Pivot Bars (#05) using the Hex Socket

Bolts M8×12 (#16).

Remove the bolts and plates from the Pivot Assemblies (#07). Set the Door Glass (#04) into the

pivots so that the holes are aligned. Make sure the vinyl gaskets are in place between the glass

and the metal plates. Firmly secure the back plate with the provided bolt. (Fig 6)