How to Guide

9Q-Wall 2 manual Ver 3 Rev 2 11/2015
Fig 10
Fig 11
7. Before installation, dry fit the Side Acrylic Wall
Panel to check the holes for proper alignment around
the fixtures.
Run several beads of adhesive on the wall throughout
the area where the Side Acrylic Wall Panel will attach,
up to the edge of the base/threshold (including the
section of the Corner Acrylic Panel where the Side
Acrylic Wall Panel will overlap).
See Fig 10 and Fig 11 for details
Make sure to apply silicone
around the hole cutouts.
NOTE: If you intend to trim your Side Acrylic Wall
Panels flush to the edge of The base/threshold, then
apply adhesive up to that area.
If you intend to allow the Side Acrylic Wall Panels
to extend beyond the base/ threshold, then apply
adhesive up to that area.