Installation Guide

“PRISM LUX / PYRAMID” Ver 3 Rev 3 01/2016
8
Fig. 7
6. Locate the Support bar (04).
Position the Support bar (04) at an angle (ideally 45°)
between the glass and the wall. Level it horizontally. Hold it
firmly and outline the bracket’s position on the wall.
Remove the Support bar (04) and detach the wall bracket
from it. Place the wall bracket against its outlined position
on the wall and mark the drilling hole.
Drill the hole using a Ø 5/16” drill bit, insert the Wall
anchor (07) and fasten the wall bracket to the wall with the
Countersunk screw ST4.2×40 (17). Attach the Support
bar (04) to the wall as shown on Fig. 8.5 and tighten the
set screws and the glass holding screw to secure the glass.
Be sure gaskets are in place to protect the glass.
Repeat these steps for the other Support bar (04).
See Fig. 8 and Fig. 9 for details.
Fig. 8