Installation Guide

“PRISM LUX / PYRAMID” Ver 3 Rev 3 01/2016

Fig. 11

8. Press the Anti-water strip (14) onto the vertical

edge of the Stationary glass (03). (Fig 12.1)

Press the Bottom anti-water strip (15) onto the

bottom edge of the Glass door (02). (Fig 12.2)

Take three measurements:

 from the top edge of the Glass door (02) to the

top edge of the inner part of the Hinge (05); (See

Fig 12.3)

 repeat this process between the top and bottom

hinges

 Measure up from the surface of the shower base to

the bottom of the inner part of the bottom hinge

Cut the Side strip (13) according to these

measurements. Notch the ends to fit into the hinge

and also around the Bottom anti-water strip (15).

Fully press the cut strips onto the vertical edge of

the glass door.

See Fig. 12 for details.

Fig. 12