Installation Guide

9PRISM PLUS manual Ver 1 Rev 2 11/2016

Fig 8

Fig 9

see step #8

for hole Ø

washer

inside

8. With both of the Bottom Brackets (#12) installed onto

the Panel glass (#01) & (#03), mark the holes for drilling

onto the threshold. (Be sure that the end of the panel glass

aligns with the marks on the threshold from step #6 to

maintain proper spacing for the door at 23-15/16”).

Remove the panel glass and drill the holes* into the

threshold for the bottom brackets.

•For installation into an acrylic threshold: *drill Ø1/8”

holes

•For installation into a tile threshold: *drill Ø5/16” holes

and insert anchors

See Fig 8 for details

9. Add silicone into the installed Stainless Steel

U-channels (#11).

Slide the panel glass into the U-channel. Tap with a

rubber mallet and a block of wood if necessary.

Install the Bottom Brackets (#12) onto the

threshold using the ST4.2 x 25 Round Head

screws (#08) with washers and decorative covers

(#10).

See Fig 9 for details