Installation Guide

13PRISM PLUS manual Ver 1 Rev 2 11/2016
Fig 14
Fig 13
13/16” shim
11. Attach the Hinges (#05) to the Stationary glass 2
(hinge panel) (#03) with the bolts facing inside of the
shower.
Carefully bring the Door Glass (#02) into the shower
between the two stationary panels.
Level up the Door Glass (#02) next to the Stationary
glass 2 (hinge panel) (#03) and fasten the hinges onto
the Door Glass (#02). Make sure the top edges of the
Door Glass (#02) and the Stationary glass 2 (hinge
panel)(#03) are flush at the top. Use a 13/16” shim
beneath the door glass during installation (see Fig 14).
See Fig 13 & 14 for details
TIP: Use a 13/16” shim beneath the door glass
to help align the door glass with the hinges. This
will also protect the threshold and the bottom of
the door glass from damage and allow spacing
for the sweep vinyl seal (#15).
See Fig 14 for details
TIP: It is advisable to allow the silicone to set
on the hinge panel glass connection with the
U-channel before hanging the door glass.
Leave the shims in place beneath the door
glass while the silicone cures, especially if an
out-of-plumb wall condition is present.
NOTE: See page #15 for details about
the Adjustable hinge features