Installation Guide

VISIONS Ver 1 Rev 7 07/2015
5
Fig. 3
3. Once the Guide rails (#03) have been cut, you will
need to reinstall the roller stoppers on each Guide rail
(#03) on both ends. It is important that these stoppers
are installed at the correct location.
Remove the existing stopper. Mark the drilling hole at
a distance of 2” from the cut off end of the Guide rail
(#03). Drill a new hole using an Ø 1/8” drill bit; then
re-attach the stopper with the screw.
ATTENTION:
Do not drill all the way through the Guide rail, only
drill into the first layer.
See Fig. 4 for details
Fig. 4
1
2
Ø1/8”
2”