Installation Guide

INFINITY-Z manual Ver 4 Rev 5 06/2017 12

Fig 14

Fig 15

Outside

Ø1/8"

3/4”

TIP: The longer Anti-Water Strips (#07) attach to the edges of the Door Glass (#04) and the

shorter strip attaches to the edge of the Stationary Glass (#05).

ATTENTION: Do Not drill the profiles throughout, only through the first layer

of the wall and glass profiles.

15. Perform the final adjustments of the assembled unit in the Wall Profiles (#02) making sure that

the bottom rail is tight to the threshold.

Drill the holes in the center of the Wall Profile (#02) into the Glass Profile (#01) using a Ø1/8” drill

bit. (Fig 15)

Secure the Wall Profile (#02) to the Glass Profile (#01) using the Round Head Screws

ST4.2×10 (#11) and raised white washers.

Cover the exposed screw heads with the Decorative Covers (#13).

14. Install the Handle (#06) to the Door Glass (#04).

Press the Anti-Water Strips (#07) onto the vertical edges of the Stationary Glass (#05) and both

vertical edges of the Door Glass (#04). Insert the Seal Gasket (#15) into the Glass Profile (#01)

starting from the bottom (Fig. 14.3). (Fig 14)