Installation Guide

INFINITY-Z manual Ver 4 Rev 5 06/2017 10

Fig 11

Fig 10

1 2

Ø5/16"

Outside

NOTE: Towel Bar must be installed on the outside of the Stationary Glass.

11. Attach the Towel Bar (#18) to the outside of the Stationary Glass (#05). (Fig 11)

10. Use a helper to hold the assembly in position and mark the drill holes on the wall through the

holes on the flange of the Wall Profiles (#02).

Gently set the assembled unit aside; drill the holes using a Ø5/16” drill bit and insert the Wall

Anchors (#14).

Apply silicone along the Wall Profile (#02) and around the holes on the wall. Also apply silicone

caulk under the Bottom Guide Rail (#03). Place the entire shower assembly back into the designated

position and secure it to the walls using the Truss Head Screws ST4.2×40 (#09). (Fig 10)