Installation Guide

INFINITY-Z manual Ver 4 Rev 5 06/2017 9

Fig 7

Fig 8

Fig 9

Fig 8

Inside

*NOTE: At this step you can reverse the handing

of the installation by flipping the assembly top to

bottom so that the panel is on the right side.

*NOTE: Before installing the frame assembly, put

the Door Glass into the shower area and lean it

against the wall with the handle holes on the

correct side for the installation.

After the frame assembly and panel glass are

installed, it may not be possible to easily get the

door glass into the shower. Always use padding

to protect the glass and shower surfaces.

9. Move the assembled frame into the designated

position on the shower base*, bathtub or threshold

(depending on your installation), and push the Wall

Profiles (#02) tight to the walls to compensate for any

out-of-plumb conditions.

Push the bottom rail down tight to the threshold and

adjust the frame to a vertical position. Confirm with a

level before marking the holes for drilling. (Fig 9)

8. Slide the Wall Profiles (#02) all the way onto the Glass Profiles (#01) on both sides. Make sure the

flange of the wall profile faces inside the shower. (Fig 8)