Installation Guide

“INFINITY-Z” Rev.2 Ver.4 08/2013
2
Preparation
1. After opening all boxes and packages, read this introduction carefully. Check that all of the needed
parts are included in the package by marking all the components on the “Detailed Diagram of
Shower Door Components”. Examine boxes and packages for shipping damage. If the unit has
been damaged, has a finishing defect, or is missing parts, please contact our customer support
department within 5 business days of the delivery date. Please note that DreamLine
TM
will not
replace any damaged products or missing parts free of charge after 5 business days or if the
product has been installed. Feel free to contact DreamLine
TM
if you have any questions.
2. Please note that you should consult your local building codes with questions on installation
compliance standards. Building and plumbing codes may vary by location, and DreamLine is
not responsible for code compliance standards for your project and will not accept any
returns.
3. If this unit is going to be installed in a new construction, install all of the required plumbing and
drainage before installing the shower. Use a competent and licensed (if required by local code)
plumber for all plumbing installation.
4. Prior to installation, ensure that the installation surface is leveled and solid and will be able to
support the total weight of the unit. Also, make sure the walls are at right angles. Irregular
installation surface level or improper angle of side walls will result in serious problems for your
installation. Please, note that some adjustments and drilling might be necessary during the
installation process.
5. This unit must be installed against finished walls and floor.
PLEASE, NOTE!
This door does have 1” out-of-plumb adjustment on each side. Make sure your
walls are vertical and your shower base or threshold is leveled.
Note: If glass has silk, print or molded designs, please make sure that clear
side faces inside the shower.
Note: Instructions are given for the shower door installation. Please, follow
the same instructions to install the tub door.
Tools Required
Caulk
Tape
Measure Pencil
Screwdriver
Phillips
Level
Gun
Caulk
Drill
Electric
Hammer
Miter saw or Hacksaw
Drill bit
Drill bit
(Ø=5/16")
(Ø=1/8")