Installation Sheet

Q-Wall 5.2 (w/two back panels) manual Ver. 1 Rev. 2 08/2015
5
3. Divide the measurement “W” by two
and place a mark in the center of the
back wall and from there draw a
plumb vertical line from top to
bottom.
This distance is shown as “W/2”.
See Fig. 3 for details.
Fig. 3
4. Determine the position of both Back
panels (09).
NOTE:
a) The Narrow side (2-3/4”) of the Back
panel cannot be trimmed and should face
the center of the back wall (as shown)
b) The Wide side (3-1/8”) of the Back panel
must be trimmed to the size of the back
wall if necessary, and should face the
corner.
See Fig. 4 for details.
Fig. 9
Fig. 4
W/2
W/2
3 1/8"
2 3/4"
2 3/4"
3 1/8"