Installation Sheet

Q-Wall 5.2 (w/two back panels) manual Ver. 1 Rev. 2 08/2015
6
5. Measure the Back Panel (09).
Width of the Back Panel has to be less than or
equal to the distance between the center line
and the corner line on the back wall in Step. 3
L
≤
W/2
If the width of the Back Panel is greater than the
distance between the center line and the corner
line on the back wall in Step. 3, you have to trim
the Back Panel to fit your measurement.
See Fig. 5 for details.
Fig. 5
6. Measure from the narrow edge of the
Back panel (09) and place a mark at a
distance of "W/2" (that you measured
in Step. 3),
From this mark, draw a straight line
from top to bottom along the wide
edge of the Back panel.
See Fig. 6 for details.
Fig. 6
L
L
W/2
W/2
to cut
Line
to cut
Line