Installation Guide

INFINITY-Z manual Ver 4 Rev 5 06/2017 7

Fig 4

Fig 5

3-1/8"

Ø1/8"

ATTENTION: Do Not drill the Guide Rail

throughout, only through the first layer.

TIP: For ease of assembly, add some liquid soap, wax or lubricant to the screws prior to

attaching the glass profiles to the guide rails. Use a low setting on your power drill to

prevent stripping the screws.

4. Secure the Bottom Guide Rail (#03) to the Glass Profiles (#01) with the Round Head Screws

ST4.2x25 (#10). (Fig 5)

3. After the Top and Bottom Guide Rails (#03)

have been cut, you will need to re-install the

roller stopper on each Top and Bottom Guide

Rails (#03) on the end that has been cut off (the

door end).

Remove the existing stopper. Mark the drilling

hole at the distance of 3-1/8” from the cut end

of the Top and Bottom Guide Rails (#03).

Drill a new hole using a Ø1/8” drill bit; then

re-secure the stopper with the screw. (Fig 4)

(Bottom Guide Rail shown)